Project case study · Galveston, TX

A Cedar Privacy Fence and Custom Gate for Ralph Velez in Galveston, TX

Ralph wanted a wooden fence that added privacy without losing curb appeal. Here is the treated cedar fence and custom gate Mustang built him, set in concrete and finished with a protective stain — and why cedar needs a particular kind of fastener to avoid a stain of its own.

  • Reviewed Nov 3, 2026
  • Source: USDA FPL Wood Handbook
  • 2 job photos
Wood gate and fence meeting a red brick wall
The finished cedar fence and custom gate meeting the brick wall at the edge of Ralph’s property.
The short answer

Mustang Fencing built a treated cedar privacy fence with a custom gate for Ralph Velez in Galveston, TX. The posts were set in high-strength concrete, the cedar panels were finished with a protective stain, and corrosion-resistant hardware was used throughout — including the gate’s hinges and latch, installed last.

Cedar panelsTreated for the coastal climate
Custom gateInstalled last, sturdy hinges
High-strength concretePosts set and aligned
Galveston, TXProtective stain applied

Sources: this project’s own documented facts; USDA Forest Products Laboratory, Wood Handbook FPL-GTR-282 (2021), Ch. 16. Checked November 3, 2026.

The job: a cedar privacy fence with a custom gate

Ralph Velez wanted a wooden fence that would add privacy and charm to his Galveston property without compromising on durability. Mustang Fencing built a treated cedar privacy fence, chosen for its resistance to Galveston’s humid, salt-heavy coastal air, along with a custom gate for easy access without giving up security.

Postholes were dug to the correct depth and the posts were anchored in high-strength concrete, with alignment double-checked at each stage. Once the framework was set, the cedar panels were installed and finished with a top-quality stain to protect the wood’s grain from moisture. The custom gate went in last, fitted with sturdy hinges and a latch system.

A labeled diagram of a treated cedar fence with posts anchored in high-strength concrete and a protective stain, next to a custom gate installed last with corrosion-resistant hinges and a latch for smooth operation and secure closure. The documented job: cedar panels, concrete-set posts, a custom gate THE FENCEtreated cedar panels Posts anchored in high-strength concrete Protective stain applied over cedar THE CUSTOM GATEinstalled last Corrosion-resistant hinges & latch Smooth operation, secure closure From this project’s own documented facts (post content + photos). Not an external source.
S-1
DrawingThe documented job: cedar panels, concrete-set posts, a custom gate
BasisPublished job facts (post content + photos)
ScaleNot to scale
The build Ralph specified: a sealed, concrete-set cedar fence and a custom gate added for access and security.
New cedar privacy fence beside a grass yard
The finished cedar privacy fence along the edge of Ralph’s grass yard.

Why cedar needs the right fastener

Cedar is naturally rich in tannins — the same compounds that give it its color and some of its natural decay resistance. Those tannins also react with plain carbon-steel fasteners: USDA’s Forest Products Laboratory notes that iron stain on cedar from the wrong fastener is common, even when the installer does the work correctly. That reaction is the reason corrosion-resistant hardware matters on a cedar fence, not just as a general durability upgrade but to avoid a specific, visible stain.

Two cedar boards compared. Left, a plain carbon steel fastener with a dark stain spreading from it, labeled cedar tannin plus iron equals dark stain, common even when installers do the work. Right, a stainless or hot-dip galvanized ASTM A153 fastener with no stain, labeled far less likely to stain the cedar. Why cedar needs the right fastener, not just any fastener PLAIN CARBON STEEL Cedar tannin + iron = dark stain Common even when installers do the work STAINLESS OR HDG (ASTM A153) No iron-stain reaction Far less likely to stain the cedar USDA FPL Wood Handbook (2021), Ch. 16: iron stain is common on tannin-rich woods like cedar with plain steel; stainless or ASTM A153 hot-dip-galvanized fasteners are far less likely to cause it.
S-2
DrawingWhy cedar needs the right fastener, not just any fastener
BasisUSDA FPL Wood Handbook FPL-GTR-282 (2021), Ch. 16 (Finishing)
ScaleNot to scale
The same cedar board reacts very differently depending on the fastener used — which is why the hardware on this fence was chosen to resist corrosion.

Cedar fence panel calculator

A straight-arithmetic estimate of how many fence panels a run needs, based on the run length and the panel width you plan to use, minus any gate opening. Not a quote — corners and waste are not included.

Arithmetic: (run length − gate opening) ÷ panel width, rounded up to the nearest whole panel. Add extra for corners and waste cuts.

How long a finish lasts on cedar before it needs recoating

USDA’s published figures for cedar/redwood siding finishes — the closest tested reference for exterior cedar. A fence specifically has not been tested, so these are shown as a reference range, not a measurement of Ralph’s fence.

Tinted finish, smooth (range 1–2 yrs)1.5 yrs (midpoint)Semi-transparent stain, smooth (range 2–4 yrs)3 yrs (midpoint)Paint / solid-color stain, saw-textured (range 10–15 yrs)12.5 yrs (midpoint)
USDA Forest Products Laboratory, Wood Handbook FPL-GTR-282 (2021), Table 16-2 (siding/decking finishes for cedar and redwood). Ask your installer which finish type was used on your own fence.
★★★★★
Amazing work will go ahead and recommend everyone in friends and family We installed 8ft tall double sided stained cedar wood fence in our backyard, it’s really looks great, installed perfectly nice finishing and cost effective, thanks mustang fencing.
Muqeet Mohammed Abdul · Google review · a year ago
★★★★★
Installed Stained cedar wood fence yesterday by mustang fencing, thanks for the beautiful work.
Shahrukh Abdul · Google review · a year ago
★★★★★
I have hired Mustang fencing services to fix my backyard fencing. Good wood to used. I really like theirs work. Best of luck
Zaidbin Saif · Google review · a year ago

Reviews shown word for word from the Mustang Fencing Services Google Business Profile (Galveston), captured 2026-11-02.

Questions we get about this

What did Mustang Fencing build for Ralph Velez?
A treated cedar privacy fence with a custom gate in Galveston, TX. Posts were set in high-strength concrete, the cedar was finished with a protective stain, and corrosion-resistant hardware was used throughout.
Why was cedar chosen for this fence?
Cedar holds up well to Galveston’s humid, salt-heavy coastal air, and its grain and natural tone were part of the look Ralph wanted.
Why does cedar need a specific kind of fastener?
Cedar’s natural tannins react with plain carbon-steel fasteners to cause a dark iron stain. USDA’s Forest Products Laboratory recommends stainless steel or ASTM A153 hot-dip-galvanized fasteners instead, which are far less likely to cause that reaction.
When was the gate installed?
Last, after the cedar panels were in place — fitted with sturdy hinges and a latch system for smooth operation and secure closure.
Does Mustang Fencing serve Galveston, TX?

Sources

Checked November 3, 2026. Rules change, so confirm with the City before you build.

  1. USDA Forest Products Laboratory, Wood Handbook FPL-GTR-282 (2021), Ch. 16 — Finishing guidance explaining iron stain from plain carbon-steel fasteners on tannin-rich woods like cedar, and the recommendation for stainless steel or ASTM A153 hot-dip-galvanized fasteners instead.
  2. USDA Forest Products Laboratory, Wood Handbook FPL-GTR-282 (2021), Table 16-2 — Published finish-life ranges for exterior cedar and redwood siding/decking, used here as the closest tested reference for how long a given finish lasts before recoating.
Free on-site estimate

Want a cedar fence built for Galveston’s coastal air?

We’ll talk through panel style, fastener choice and finish before any order goes on a written estimate.

Page reviewed November 3, 2026 by Mustang Fencing Services, Galveston. Next review due May 2027.